Bostitch N66BC-1 Use and Care Manual download pdf (Page 10)

-10-

MAINTAINING THE PNEUMATIC TOOL

When working on air tools, note the warnings in this manual and use extra care evaluating

problem tools.

REPLA

CEMENT PARTS:

BOSTITCH replacement parts are recommended. Do not use modified parts or parts which will not give

equivalent performance to the original equipment.

ASSEMBLY PROCEDURE FOR SEALS:

When repairing a tool, make sure the internal parts are clean and lubricated. Use Parker “O”-LUBE or

equivalent on all “O”-rings. Coat each “O”-ring with “O”-LUBE before assembling. Use a small amount of oil on

all moving surfaces and pivots. After reassembly add a few drops of BOSTITCH Air Tool Lubricant through the

air line fitting before testing.

AIR SUPPLY-PRESSURE AND VOLUME:

Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate because of

undersize fittings and hoses, or from the effects of dirt and water in the system. Restricted air flow will prevent

the tool from receiving an adequate volume of air, even though the pressure reading is high. The results will be

slow operation, misfeeds or reduced driving power. Before evaluating tool problems for these symptoms, trace

the air supply from the tool to the supply source for restrictive connectors, swivel fittings, low points containing

water and anything else that would prevent full volume flow of air to the tool.

TOOL OPERATION CHECK:

AUTION: Remove all fasteners from tool before performing tool operation check.

1. CONTACT TRIP OPERATION:

A. With finger off the trigger, press the contact trip against the work surface.

THE TOOL MUST NOT CYCLE.

Hold the tool off the work surface, and pull the trigger.

THE TOOL MUST NOT CYCLE.

With the tool off the work surface, pull the trigger. Press the contact trip against the work surface.

THE TOOL MUST CYCLE.

D. W

ithout touching the trigger, press the contact trip against the work surface,

then pull the trigger.

HE TOOL MUST CYCLE.

2. SEQUENTIAL TRIP OPERATION:

A. Press the contact trip against the work surface, without touching the trigger.

THE TOOL MUST NOT CYCLE.

Hold the tool off the work surface and pull the trigger.

THE TOOL MUST NOT CYCLE.

Release the trigger. The trigger must return to the trigger stop on the frame.

C. Pull the trigger and press the contact trip against the work surface.

THE TOOL MUST NOT CYCLE.

D. With finger off the trigger, press the contact trip against the work surface. Pull the trigger.

THE TOOL MUST CYCLE.

ACCESSORIES AV

AILABLE

BC601 4 oz. Bostitch Air -Tool Lubricant

BC602 1 pint Bostitch Air -Tool Lubricant

BC603 1 pint Bostitch “Winter-Formula” Air-Tool Lubricant

BC604

1 quart Bostitch Air -Tool Lubricant

100679

O-Ring Lube (1lb

can)

851325 Locite Grade 271 (.02 oz.)

851385 Locite Grade 242 (.02 oz.)

CNTK1 Kit, Contact Trip Conversion (Black Trigger)

TVA6 Trigger Valve Assembly

SEQ4 Kit, Sequential Trip Conversion (Gray Trigger)

N66C-RK Rebuild Kit- N66C, N66BC, N75C

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Comments to this Manuals

No comments

Bostitch N66BC-1 Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Nail Gun Bostitch N66BC-1