Bostitch MIIIFS Specifications

BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TOUNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESEINSTRUCTION

Trigger valve housing leaks air O-ring cut or cracked . . . . . . . . . . . . . .Replace O-ringTrigger valve stem leaks air O-ring/seals cut or cr

-11-TO REPLACE PISTON:a. Insert the flats on the lower end of the driver piston stem carefully into the end of piston and plunger wrench, BC1009.b. U

-12-ACCESSORIES AVAILABLEBC1297 Handle (short)105043 Bumper105056 Spacer (5/16” Special)104301 Mallet

-2-INTRODUCTIONThe Stanley-Bostitch MIII is a precision-built tool, designed for high speed, high volume fastening. These tools will deliver efficient

-3-SAFETY INSTRUCTIONSEYE PROTECTIONwhich conforms to ANSI specifications and provides protectionagainst flying particles both from the FRONT and SIDE

-4-MIII TOOL SPECIFICATIONSOPERATIONAll screws and nuts are english.FASTENER SPECIFICATIONS:TOOL AIR FITTING:This tool uses a 3/8” N.P.T. male plug.

AIR SUPPLY AND CONNECTIONSDo not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing

-6-EYE PROTECTION which conforms to ANSI specifications and provides protec-tion against flying particles both from the FRONT and SIDE should ALWAYS b

TOOL OPERATIONEYE PROTECTION which conforms to ANSI specifications and provides pro-tection against flying particles both from the FRONT and SIDE shou

IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANU-AL OBSERVE THE FOLLOWING FOR SAFE OPERATION• Use the STANLEY-BOSTITCH pneumatic tool only for

-9-MAINTAINING THE PNEUMATIC TOOLWhen working on air tools, note the warnings in this manual and use extra care evaluating problem tools.CAUTION: Pus